Ford Windstar front-wheel drive minivans are designed to accommodate households on the go. When you intend to tow a trailer or boat along with your Ford Windstar, you need to install a towing hitch. This can be a comparatively simple process for those who are mechanically inclined and have the proper tools. Be certain that your engine and transmission are in full working order before towing. It’s also a good suggestion to do an oil change and a tuneup before you tow together with your Windstar.
Ford Windstar Trailer Hitch Installation Instructions
1. Place the 2 wheel chocks in front of both front wheels and set the jack beneath the rear axle. Elevate your Windstar with the jack, and place the 2 jack stands beneath each side of the rear axle. Decrease your Windstar onto the jack stands and transfer the jack off to the side.
2. Thread one finish of the all-function electrical wire into the closest drill hole on the motive force’s aspect frame rail. Push the wire toward the entrance finish of your minivan till you attain the side access panel, the gap between the two holes is roughly 1 half of feet. The wire is used simply to snake the bolts into the correct holes in the frame.
3. Wrap the tip of the wire around the threads of a bolt from the hardware mounting kit. Pull the first finish of the wire down by means of the drill hole on the different finish of the body rail until the bolt threads come through. Repeat these steps to get the bolt into the drill hole on the passenger aspect body rail.
4. Slide the hitch onto the 2 bolts, so the hitch sits between the bolt holes and the bolts. Twist the bolts clockwise manually till they’re tight.
5. Modify the hitch forward or back and to the left or right by pushing it till the biggest hole on the hitch matches up with the largest hole on the frame. Tighten the bolts with a ratchet and socket.
6. Locate the four remaining holes on the hitch that need to be drilled within the frame for the bolts to go through. There are two holes on each side of the large gap you used to match collectively the hitch and frame earlier. Mark these holes by drilling a 1/4 inch gap with a 1/4 inch drill bit, then drill the holes during with a half of inch drill bit.
7. Thread the four remaining bolts down through the holes you simply drilled with the wire, using the same method from the earlier steps.
8. Tighten the entire bolts with the ratchet and socket.